ATEN VE2812EUT, Руководство пользователя

Страница: 27 / 38

Chapter 3. Operation
17
RS-232 Commands
You can change the input mode using RS-232 commands. Refer to the table
below for a list of available tasks and the corresponding commands.
Note: To switch to RS-232 mode, press the Input Switch pushbutton for 5
seconds. For RS-232 command mode, the Auto Switch Mode LED,
HDMI Mode LED, and VGA Mode LED light orange and blink 3 times.
For RS-232 bypass mode, the Auto Switch Mode LED, HDMI Mode LED,
and VGA Mode LED light orange and blink 1 time. The RS-232 status is
kept even when the unit is powered on and off. For detailed LEDs
behavior, see LED Display, page 6.
Type the corresponding command to execute a task. For example, to enable
automatic switching, type
swmode next and then press [Enter] .
Task
Command
Control Input Port
Enable automatic input switching swmode next N/A N/A
Disable automatic input switching swmode off N/A N/A
Set the unit to the HDMI mode sw i 01
Set the unit to the VGA mode sw i 02
View the current input mode settings read N/A N/A
Note:
Š
Press [Enter] to execute a command.
Š
The current input mode setting is also indicated by the Auto Switch, HDMI, and
VGA LEDs.
Š
To switch to RS-232 mode, press the Input Switch pushbutton for 5 seconds. For
RS-232 command mode, the Auto Switch Mode LED, HDMI Mode LED, and VGA
Mode LED light orange and blink 3 times. For RS-232 bypass mode, the Auto
Switch Mode LED, HDMI Mode LED, and VGA Mode LED light orange and blink 1
time. The RS-232 status is kept even when the unit is powered on and off. For
detailed LEDs behavior, see
LED Display , page 6.