ATEN PG Series, Руководство пользователя

Страница: 18 / 108

Chapter 1. Introduction
6
Note: Holes for ATEN Lok-U-Plug cable holders are located around the
outlets. See
Securing the Cables , page 14, for further information.
Status Panel
4 power cord Connects the unit to an AC power source.
5 outlet status LEDs These LEDs indicate outlet status.
Lights orange for powered on.
Off for powered off.
No. Item Description
1 USB Type-A
port
(firmware
upgrade /
log export) Connects to a USB Type-A storage device for firmware upgrade
or log export.
2 COM + PON
port
Š
COM: Connects to a hardware or software controller for
remote control.
Š
PON: Connects to KN Series for cascading up to 16 PG
PDUs.
3 LAN 1 (10/
100/1000M) The cable that connects the unit to the Internet, LAN, WAN, or to
cascade up to 64 PG PDUs plugs in here.
4 reset button This button is recessed and must be pushed with a thin object,
such as the end of a paper clip.
Š
Press and release to reboot the device.
Š
Press and hold for more than three seconds to reset the eco
PDU back to its factory default settings.
5 sensor port This RJ-45 port is currently reserved for future expansion.
6 LAN 2(10/
100M) The cable that connects the unit to the Internet, LAN, WAN, or to
cascade up to 64 PG PDUs plugs in here.
No. Item Description
5 6 7