ATEN CS1762a, Руководство пользователя

Страница: 34 / 54

CS1762
A
/ CS1764
A
User Manual
26
Firmware Upgrade Mode
To set the CS1762
A
/ CS1764
A
to Firmware Upgrade Mode, do the following:
1. Invoke HSM (see page 22).
2. Key in:
upgrade
3. Press [Enter] . The orange front panel LEDs flash to indicate Firmware
Upgrade Mode is in effect.
Note: To exit Firmware Upgrade Mode, you must power off the switch.
See
The Firmware Upgrade Utility , page 33, for details.
Restore Default Settings
To reset the CS1762
A
/ CS1764
A
to its default hotkey settings, do the
following:
1. Invoke HSM (see page 22).
2. Press [R] [Enter] .
See Hotkey Default Settings , page 46
Video DynaSync
Video DynaSync is ATEN’s exclusive technology that eliminates boot-up
display problems and optimizes resolution when switching between ports. To
invoke Video DynaSync, do the following:
1. Invoke HSM (see page 22)
2. Press [D] .
Note: If the monitor is disconnected and reconnected, the CS1762
A
/
CS1764
A
re-executes Video DynaSync.
Alternate Manual Port Selection Settings
To toggle between the default and the alternative front panel pushbutton
manual port selection settings, do the following:
1. Invoke HSM (see page 22)
2. Press [S] .
See Alternate Manual Port Selection Settings , page 17, for full details.