Chapter 1. Introduction
9
CE924L (Local Unit) Front and Rear View
No.
Component
Description
1
USB Type-B port
The USB cable from your computer or USB hub plugs
in here.
2
DisplayPort input
ports
Connect two DisplayPort cables from a computer to
these two DisplayPort ports.
3
link LED
Indicates the transmission from local and remote units
is stable, see page 21 for more information.
4
power LED
Indicates the unit is receiving power, see page 21 for
more information.
5
grounding terminal
Grounds the unit to prevent damages from power
surges or static electricity.
6
power jack
The cable from the power adapter connects here.
7
RS-232 serial port
This RS-232 serial port is for connecting to a serial
terminal for configuration.
8
audio ports
These mini stereo ports connect to the speaker
(green) and microphone (pink) ports on the computer.
9
HDBaseT output port
The Cat 5e/6/6a cable that connects the local and
remote units plugs in here.
10
long reach mode
switch
Put the switch to ON to enable the long reach mode,
see
11
firmware upgrade
switch
Put the switch to ON to enable the firmware upgrade
mode.
Note:
The firmware upgrade mode is reserved for
technical support. To upgrade the device’s firmware,
please contact ATEN customer support.
CE924L (Remote Unit) Front View
CE924L (Remote Unit) Rear View
1
2
3 4
5
7
6
8
9 10 11
