5
USER INSTRUCTIONS
Step One: Start Your Jump Starter
Press JUMP START button or LED light button to get start, and the charge LEDs will be on, indicating the battery
capacity.
Note:
The charge LEDs will flash when the jump starter is connected to AC/DC charger. And they will stop
flashing when fully charged. Please note that only LED light is available during charging. All four Charge LEDs
will be on when the device is fully charged.
PROTECTION
1.Battery Discharge Temperature Protection
Temperatures are not allowed to exceed 45°C when jump starting, or the unit will alarm then automatically shut
down.
2.Battery Charge Temperature Protection & Over-Temperature Protection
Charging will be disabled when the temperature exceeds 45°C or is below -20°C.
3.Reverse Polarity Protection
If battery clamps are reversely connected to the battery, the JUMP START button willflash red and the jump start
will be disabled.
The device will automatically turn off when either of its clamp is taken off.
The unit will automatically shut off after 60s if there is no direction.
4.Battery Clamp Drop-Off Protection
If the battery clamps do not make good contact to terminals or if any of them drops, and the jump start will be
disabled.
Step Two: Check The Charge Level
Please make sure that whether the charge level of the internal battery is sufficient for jump start. If two or more
charge LEDs are on, indicating that it can be used to jump start your vehicle. If there is only one charge LED on,
please fully charge the battery before jump start.
Step Three: Jump Starting
Connect the jump starter to your vehicle's battery, then press JUMP START button to jump start your vehicle, and
the JUMP START button will become solid white. Please note that each press offers a jump start at a time.
Note:
If battery clamps are correctly connected to the battery, and the vehicle battery voltage is between 2V and
17V, the JUMPSTART button will flash white for three times and then be constantly on.
If the voltage of the jump starter is higher than that of your vehicle's battery, it will charge the car's battery in 60A-
100A for 15s. Then the jump starter will automatically turn off. The USB output button and the JUMPSTART button
will flash white and red alternatively.
After pushing the JUMPSTART button and the device is powered on, if battery clamps are not detected to be
connected to the battery, push the button again and the device will shut down.
Step Four: Failure To Jump Start
If step 3 fails, the jump starter will automatically shut down its output. So please try another 3 times, if it still fails,
DO NOT use this product, because it may get damaged.
Step Five: Force Start
Jump starting will usually fail if the battery voltage of your vehicle is below 2V. And this is where force start comes
into play.
Connect the battery clamp to your vehicle's battery. Press the JUMP START button, then press both the JUMP
START button and LED LIGHT button simultaneously for 5 seconds. Then the JUMP START button will flash for
10 seconds, during which force start is initiated. After that, please first turn off the jump starter, then take the
battery clamp from the terminal of the battery. Please note that force start will be off after 60 seconds.
