Adjust Ball Joint Mechanism
E
As LCD Manufacturers are constantly releasing new monitor models, Atdec does not accept responsibility it the mounting hole pattern does not comply with the international VESA standards.
Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published: 29.08.07©
Adjust Donut Clamps
C
Mount Displays
D
Cable Management
F
100mm (4”)
75mm (3”)
100mm
(4”)
75mm
(3”)
LOOSEN
TIGHTEN
Adjust the Ball Joint
Mechanism to suit the
weight of your display.
Tighten or loosen
screws evenly with the
supplied 2.5mm Allen
Key, 1/4 turn at a time.
2.5mm
Allen Key
Cable
Balls
Cable
Clips
IMPORTANT:
When tightening the Donut
Clamp, each of the Donut
bolts must be tightened
evenly, as failure to do so will
damage the Donut Clamp.
Do not over tighten as this
may also result in damage.
Choose the correct Mounting Screws supplied in the bits
box and attach the display as shown.
Note:
Extension
Clips are included
to suit VESA 100mm
x 100mm (4” x 4”)
Mounting Hole
Patterns.
Follow steps below to adjust the position of Donut Clamps. Ensure the Cable Slots
in all the Poles are facing to the rear.
LOOSEN
POSITION
TIGHTEN
C.1.
Loosen Donut Bolts evenly
using the supplied 5mm
Allen Key
C.2.
Slide the Donut Clamp to
desired position
C.3.
Tighten Donut Bolts firmly
using the supplied 5mm
Allen Key
Note:
Ensure enough
slack is left in cables to
allow for movement.
Insert display cables into the slots in each pole, using
Cable Balls to hold them in place.
Note:
When the slot in each pole cannot be used, use
the supplied Cable Clip’s to secure the display cables.
