AWMS-BT40 Page 3 of 4
5. Attach display
4. Set height
4.1
Ensure height is
sufficient for display to
clear desk once in place.
4.2
Firmly tighten hand
knob at chosen height.
Fit post cap.
5.1
Set VESA plate to
open
position.
5.4
Set VESA plate to
closed
position by sliding
clips on both sides inwards.
5.3
Centre VESA plate
close to post and
slowly lower until bar
on VESA plate sits in
saddle in bracket.
5.2
Lift display until
VESA plate is above the
bracket.
5.5
Adjust display tilt
angle by gripping edges
of screen and rolling up or
down to desired position.
WARNING:
Never loosen
knob while display
is on bracket
WARNING:
Use two people to
install display
TIGHTEN
MEASURE
≥
Display
height
between
brackets
D
MEASURE
to
ensure clearance
to desk
D
MEASURE
≥
Display
height
between
brackets
D
MEASURE
to
ensure clearance
to desk
D
OPEN
WARNING:
Do not loosen
hand knob once
display attached
CLOSED
TILT KNOBS
OPEN
E
OPTIONAL
ADJUSTMENT -
TILT FRICTION
Clockwise = More friction
Anticlockwise = Less friction
4mm hex key
can be used to
reduce tilt
friction (for
light screen) or
increase tilt
friction (for
heavy screen)
5.6
Set display
angle by tightening
both tilt knobs.
