AWMS-NDB-F Page 5 of 7
3.
Mount Notebook Tray onto arm
3.3
Push the lever down
to secure it to the arm
assembly.
3.2
Ensure that the Notebook Tray is seated
fully into the receptacle at the end of the
display arm. There should be
no
gap.
3.1
Insert Notebook Tray into
the display arm
Gap
No gap
Note:
Ensure the lever is
unlocked when fitting.
4.
Mount notebook computer
4.1
Adjust the support tabs to
suit the width of the notebook
computer ensuring that cable
ports are not obstructed.
4.2
To increase stability, use the
self adhesive Hook-and-Loop
Fasteners supplied.
a.
Peel off the backing paper to
the fasteners.
b.
Attach fasteners to both the
Notebook Tray and notebook
computer.
c.
Ensure that each set of
fasteners are correctly aligned
i.e. Hook to Loop.
5.
Adjust tilt tension & install security screw
5.1
Use the allen key to adjust the tilt tension until the tray
holds in a vertical position at the end of the arm.
Note:
Support
tray while
adjusting.
5.2
(Optional) Tilt the head upwards to install the optional
security screw.
2.
Fit arm onto Base
2.1
Push arm onto shaft.
2.2
Ensure arm is fully pushed onto shaft.
2.3
Tighten joint screw.
Note:
Check the
arm rotation is
smooth after
tightening.
Tighten
Loosen
Tighten
Loosen
