AD-WFP-5060 Page 2 of 2
J
C
Slot Dimension
Ø8 x 40mm
*Fasteners shown are not included
NOTE:
• Always use multi-washers
M-F
.
• Use the shortest combination of spacers (if necessary) ensuring the
display is not loose and screws are not forced too deep into the display.
M-C (M6x30) /
M-D (M8x30)
M-C (M6x30) /
M-D (M8x30)
M-F
M-G
M-F
M-G
M-H
M-H
M-F
M-F
M-G
M-H
M-H
M-G
M-F
M-H
M-F
M-C (M6x30) /
M-D (M8x30)
M-E (M8x50)
M-E (M8x50)
M-E (M8x50)
M-A (M5x14) /
M-B (M6x14)
M-F
No portion of this document or any artwork contained herein should be reproduced in any way without
the express written consent of Atdec Pty Ltd. Due to continuing product development, the manufacturer
reserves the right to alter specifications without notice. ©
20210811
1
2
3
1. Mount the Wall Plate to the Wall
NOTE:
• Choice and supply of appropriate wall plate fasteners is the
responsibility of the installer.
• Consult a preferred fastener supplier or a structural engineer to
select fasteners which are most appropriate for the weight of
the display and wall construction method.
• Wall plate
must
be level. Verify using a quality spirit level tool
or the included spirit level
C
• On a Stud Wall or Drywall use a good quality Stud Finder to
position mounting fasteners in the centre of studs.
• On a Masonry Wall avoid positioning Wall Plate mounting
fasteners in a mortar join.
2. Attach the Display Brackets to the Display
3. Hook the Display onto the Wall Plate
4. Conceal Straps and Lock Display
3.1.
Angle the display and hook the Display Brackets over the top
of the Wall Plate. This should be completed by two people.
3.2.
While supporting the display, simultaneously pull each strap
down and lower the display until it is parallel with the wall.
NOTE:
To ensure the display brackets have engaged with the wall
plate and the display cannot be tilted upwards, gently pull
the display forwards from the bottom of the display.
4.1.
Conceal straps behind the display ensuring they are not
visible from the desired viewing angle
4.2.
(OPTIONAL) To prevent theft of the display, add a
padlock to each display bracket.
NOTE:
Releasing the display from the Wall Plate requires two
people. To do so, retrieve each strap from its concealed
position, then pull both straps downward and whilst holding
them down, tilt the display upwards to clear the lower edge
of the Wall Plate. The straps can then be released and the
display lifted off. This should be completed by two people.
Max. Ø4.5mm
