16
3
2
3
20
19
18
1
3
2
4
5
6
7
8
9
10
11
14
13
12
15
16
17
21
ASSEMBLY
(refer Figure 3 below)
1. Attach front caster (# 1) into left main frame (# 4) and right main frame (# 5) with M8x16 bolts and washers (# 2 & 3).
2. Attach rear caster (# 6) into rear support (# 7), with M8x16 bolts, washers and nuts (# 2, 3 & 16).
3. Insert left main frame (# 4) in right main frame (# 5).
4. Attach upright (# 6) and rear support (# 7) into the main frame assembly with two M12x100 bolts and nuts (#12 & 13)
and four M14x110 bolts, washers and nuts (No. 9, 10 & 11).
5. Attach lifting strap (# 14) to the mouting ear of upright and main frame with M8x34 bolts, washers and nuts (# 3,15
& 16).
6. Attach power unit (# 17) onto the upright assembly.
7. Insert load leveler handle (# 18) to rear support (#7) with bolts and pin (# 19 & 20)
8. Attach the chain (# 21) onto upright assembly.
Figure 3- Assembly Drawing for Model Atd-7227
3
•
Read and understand all warnings and instructional
material provided on and with this product before use.
• Do not exceed rated capacity.
• Use only on smooth, hard, level surfaces capable
of sustaining the load.
• Before moving, lower the load to the lowest
possible point and assure that the load is centered
and secured with a load restraint device.
• Apply load as close to the vertical position of the
lifting arms as possible.
• No alterations shall be made to this product.
• Failure to heed this warning may result in personal
injury as well as property damage.
!
WARNING
BEFORE USE
1. Inspect before each use. Do not use if bent, broken,
leaking or cracked components are noted. Ensure that
casters, rollers and lifting arms move freely. Check
and tighten any loose assemblies.
2. Verify that the product and the application are
compatible, if in doubt call Atd Tools Technical
Service (636)272-9050.
3. Read, understand and follow vehicle manufacturer’s
recommended tire change procedures.
4. With ram lowered, locate and remove oil filler plug.
This purges the hydraulic system of pressurized air
trapped in reservoir. Check fluid level. Proper level is
level with filler plug hole.
5. Reinstall oil filler plug.
Atd7227-M0