Care and Maintenance
Cleaning:
CAUTION-Before cleaning the fan be sure to disconnect power cord from the plug.
Clean the grille surface with a clean damp cloth. Do not use harsh chemical or abrasive cleaners.
DO NOT IMMERSE THE FAN OR ANY WIRES IN WATER. Replace front grille before fan use. Allow
fan to dry completely before use. Periodic grille cleaning with a vacuum will prevent dust build up.
The motor is sealed and does not require any interior maintenance, cleaning or lubrication.
Maintenance:
The Internal motor bearings are permanently lubricated at the factory and do not
require any additional lubrication.
Repair:
DO NOT OPERATE THE FAN WITHOUT THE GRILLE IN PLACE. DO NOT USE THE FAN IF IT
HAS MALFUNCTIONED OR BECOME DAMAGED IN ANY WAY.
Storage:
Keep original carton for storage of the fan. Coil and tie the power cord to avoid damage
during storage.
Fuse Replacement:
1. Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on
cord.
2. Open fuse cover by sliding open fuse access cover on top of attachment plug towards blades.
See Fig. 15.
3. Remove fuse carefully. Use a small tool to pry the end of the fuse from holder cavity. Be careful
not to break glass window. See Fig. 16.
4. Replace fuse. WARNING: Risk of fire. Replace fuse only with identical 2.5 or 5.0 Amp, 125 Volt
fuse (3.6mm x 10mm). Be sure fuse is properly seated within its cavity.
5. Close fuse cover by sliding it back to its original closed position. See Fig. 17.
Fig. 15
Fig. 16
Fig. 17
Tips: Do not overexert when replacing the fuse or damage may occur. If it is hard to close the
access cover, make sure the fuse is fully inserted.
