Page of 13
6
ON / OFF SWITCH
WARNING!
Before connecting a tool to a power supply, be sure that the voltage supply is the same as that
specified on the nameplate of the tool, with the ATD-10531 it is 120VAC. A power supply with a voltage greater
than that specified for the tool can result in serious injury to the user, as well as damage to the tool. If in doubt, do
not plug in the tool. Using a power supply with a voltage less than the nameplate rating is harmful to the motor.
• To switch on, set the variable speed dial (6) to 1 and push the on/off switch (8) to “I”.
• To switch off, reset the variable speed dial (6) to 1 and push the on/off switch (8) to position “0”.
VARYING THE SPEED
The speed of the tool can be regulated by adjusting the variable speed dial (6); for the lowest speed adjust the dial
to the number 1, for full speed adjust the dial to MAX.
Low Speed Use: Certain materials (some plastics) require a relatively low speed because at high speed the friction
of the tool generates heat and causes the plastic to melt. Slow speeds are usually best for polishing applications
and delicate projects such as fragile model parts. It is recommended that the various shape grinding stones be
used at a low speed to prevent them from becoming too hot and deteriorating.
High Speed Use: Higher speeds are better for carving and shaping materials. Metal and glass projects require
high speed drilling should also be done at high speed.
CAUTION:
Placing excessive load on the rotary tool while it is running at low speeds may cause it to overheat and
the motor to fail.
Note:
Do not put the machine down while the motor is still running. Do not place the machine on a dusty surface,
as dust particles may enter the machine.
HOLDING THE TOOL
•
Small milling cutters/grinders pencils - high speed
For jobs such as milling or engraving where precision is required, hold the mini-drill like a pen.
•
Large milling cutters/grinders pencils - low speed
For heavier work like cutting or grinding hold the machine in the palm of your hand.
CHANGING ACCESSORIES
1. Make sure that the machine is switched off and the plug removed from the power before you change any
accessories.
2. Press and hold down the spindle lock button (4) and unscrew the collet nut (2).
3. Loosen the collet nut (2) fully using the 2-in-1 wrench provided.
4. Select a suitable Collet for the accessory to be used and insert it in the collet nut shaft.
5. Insert the selected accessory into the collet.
6. Tighten collet nut (2) fully using the 2-in-1 wrench provided. (Always ensure bits are tight before
commencing any work with your tool).
ATTACHING A CUTTING/SANDING DISC
1. Locate the disc holder in the collet nut (2).
2. Remove the screw from the end of the disc holder with the 2-in-1 wrench provided, and insert the screw
through the cutting disc.
3. Replace the screw and cutting disc then tighten the cutting disc onto the holder. (Do not over-tighten)
Содержание ATD-10531
Страница 11: ...Page of 13 11...
