Once the hooks are through the square openings in the base of the heater, push
the foot towards the front of the panel heater until it is unable to move any
further forward.
Install the locking key into the square opening in the base of the foot and fix it into
place with the screw provided.
Repeat this procedure for the other foot and then return the heater to the upright
position.
Please note the heater will not operate if it is not in the upright position.
4. USE –
DO NOT COVER THE HEATER
To turn the heater on
move the red operation
switch on the timer to
either the On position or
Timer position.
When the switch is in the
On position the heater will
operate continuously
under the control of the
thermostat knob once a
heat output is selected.
To select a heat output,
turn on either of the red
neon switches on the right side of the heater. Turning on one switch will operate half
heat, both switches on together will give full output. This selection and also the
thermostat work in both “on” and “timer” modes.
The Timer mode is selected by moving the red operation switch to the timer position.
The timer is a 24-hour programmable unit with 15-minute interval settings. To set the
time, rotate the outer ring in a clockwise direction until the time of day is correct and
the time indicator is in the correct place. Do not turn the outer ring anti-clockwise.
