AT&T Syn248 SB35020, Руководство по установке и настройке

Страница: 80 / 116

Syn248 Installation and Configuration Guide Back to Contents
Device Configuration 79
Setting Intercom Call Forward–No Answer
Intercom Call Forward–No Answer
is an administrator setting to handle unanswered
Intercom calls for each Deskset, including outside calls that have been routed to a
Deskset by a Phone Line Call Forward–No Answer setting. See
“Configuring Phone Line
CFNA” on page 41 .
By default, Intercom calls are forwarded to Voicemail after they ring for 15 seconds. You
can change the target destination to another extension or to an outside phone number,
or you can turn off call forwarding when there is no answer. You can adjust the delay
from 5 to 45 seconds.
To set up Intercom Call Forward–No Answer:
1. On the
Admin Settings
menu, press 1 to display the Intercom CFNA settings.
2. Press

or

to select a target:

Mailbox
.

Ext
. Then press

and enter a valid extension in the
to Ext:
field.

Phone#
. Then press

and enter a valid phone number. Before you can save
this setting, “Fwd/Trans to Outside Line” must be enabled.

OFF
. Calls will not be forwarded. Go to Step 5.
3. Press

to highlight the
Delay
before forwarding.
4. Press

or

to adjust the delay time in five-second increments.
5. Press to accept the change and display the
Admin Settings
menu.
Calls forwarded to outside lines use two telephone lines. You can limit the
duration of calls forwarded to outside lines with the
Timer for Forwarded and
Transferred Outside Calls
setting. See “Changing the System Basic Settings”
on page 30.
You can also disable
Fwd / Trans to Outside Line
individually for each
extension. See “Fwd/Trans to Outside Line” on page 80. If
Fwd / Trans to
Outside Line
is disabled, you cannot change the target destination to an
outside phone number.
I
Q
tercom CFNA
7DUJHW 0DLOER[
'HOD\>VHF@
Save
Save