background image

Install the Back-up Battery

Remove the lid from the battery compartment. 
Insert the battery connection cable into the battery port. 
Place the back-up battery in the battery slot and replace the battery cover.

Turn on Your Device

Plug the power cord into an electrical wall outlet that is not controlled by 

a wall switch. 
Insert the small end of the power cord into the Power Input port on the 

back of your Wireless Home Phone Base.
Press and hold the On/Off button for 5 full seconds until the signal 

strength light comes on.

Check the Wireless Signal

Raise antenna to an upright position.
Confirm signal strength light is green for optimal performance.  

Yellow indicates a moderate signal and may be sufficient.

Connect the Device to a Phone

1)   Unplug your phone  

from your home  

phone wall jack. 

2)   Plug your phone into the “Phone 1” 

port on the Wireless Home Phone 

Base, using your existing phone 

cable or included phone cable.

IMPORTANT:  

DO NOT plug the Wireless Home 

Phone Base into your home phone wall jack.

Place a Test Call

Place a test call from your connected home phone. Make sure to use 

10-digit dialing, even for local phone calls.
For best results, place the cordless phone base at least 12 inches from  

the Wireless Home Phone Base. 

NOTE: Keep your cordless phone plugged into a power outlet.
 

Set up Voicemail and Additional Phones

Voicemail is included with your service. Dial “1” to set up and access. If 

using an answering machine, set it to fewer than 5 rings and connect it to 

the “Phone 2” port. The Phone 1 and 2 ports use the same phone number.
To place phones throughout your home, use a cordless phone system 

with multiple handsets. Wall jacks are not used with the Wireless Home 

Phone Base.

On/Off

Press and hold 5 seconds

Отзывы: