Computer Monitor
Logging
Zone Option Switches
Zone Expansion Unit
Option Switches
Is a PC computer connected to the RS-232 port of the PagePac Plus
controller for the purpose of logging paging activities? If so, you will want
to program the controller to send signals to it, and turn ON/OFF the
Attendant Access, Telephone Access, and Night Bell signals that would
trigger the monitor to log the event.
The 8 Zone Option switches on the rear of the PagePac Plus unit MUST
be set to match the zone option to be programmed. The slide switch for
each zone must be manually set to Contact Closure (to switch on/off a
device, such as a door security lock, remote amplifier, etc.), Input, or Audio
Output, depending on the programmed mode selected for each zone. See
Zone Map and Zone Configuration Tables, (to be filled out in the
Programming and Operation Guide). The Zone Option switches must be
set before the PagePac Plus system is powered up, and therefore before
programming commences.
The 16 Zone Option switches on the Zone Expansion unit must also be
configured to match the intended zone mode. It is recommended that the
paging zone decisions be made and diagramed prior to beginning
programming. See Zone Map and Zone Configuration Tables, in the
Programming and Operation Guide. The Zone Option switches must be
set prior to system power-up.
Communication System Interface
The telephone interface has four possible modes of operation to
accommodate a variety of systems. They are as follows:
■
Dry loop, 600 ohms
■
Dry loop, Hi Z
■
Ground start
■
Loop start
Set the Telephone Mode Selection switch on the PagePac Plus controller
unit to the type trunk circuit provided by your host equipment. Refer to
3-18
lnstalling the Hardware
Содержание PagePac Plus
