AT&T OneVision DEFINITY G3 Fault Management and integration, Руководство пользователя

Страница: 22 / 153

Introduction
1-10 Issue 2 April 1996
has completed refreshing data from the PBX, Fault Management updates the
alarm and circuit pack mismatch displays that use the data. This data includes:
Fault Management uses the following refresh categories:
■
Startup Refresh
■
Configuration Data Refresh
■
Bulletin Board Refresh
■
Alarms and Errors Data Refresh
Each refresh process differs slightly from the others. The next subsections
describe these operations.
Startup Refresh
Startup refresh can occur when you invoke the application from the NMS. By
default, it occurs automatically on startup. The Fault Management Startup screen
displays the following message indicating the status of the startup refresh.
Refresh in progress, estimated delay 250 seconds, 50
seconds elapsed.
Startup refresh updates the following information.
If the Proxy Agent is unable to connect to the PBX and refresh the data, the
startup refresh fails. In this case, the following message appears when you
invoke Fault Management from the NMS.
Refresh on startup failed! Continuing with cache data.
Turning Off Startup Refresh
You can turn off the startup refresh option as follows:
■
Alarm data
■
Error data
■
Bulletin board data
■
External devices
■
Cabinet data
■
Trunk group
■
Configuration data
■
Vintage data
■
DS1
■
Alarm data
■
Error data
■
Bulletin board data
■
External devices
■
Cabinet data
■
Trunk group
■
Configuration data
■
Vintage data
■
DS1