5
Getting started
Replacing a handset
You may need to de-register your handsets if:
You have the maximum number of registered handsets (four) and
you need to replace a handset.
-
OR -
You wish to change the designated handset number of your reg-
istered handsets.
You must first de-register ALL the handsets, and then re-register
ALL the handsets you wish to use.
Please read carefully through all the instructions on this page
before beginning the de-registration process.
To �e-��egis��e�� all �an�se��s
. Press and hold
HANDSET LOCATOR
on the telephone base
for about 0 seconds (until the
IN USE
light turns on and
starts to flash), then release the
HANDSET LOCATOR
button.
. Immediately press and release
HANDSET LOCATOR
again.
You must press
HANDSET LOCATOR
while the
IN USE
light
is still flashing. (The light flashes for about seven seconds.)
3. The handset(s) will show
CONNECTING...
and it will take about
0 seconds to complete de-registration. ALL handsets will
show
NOT REGISTERED
if de-registration was successful.
4. To re-register the handset(s) to the telephone base, follow the
registration instructions on page 3-4.
NOTES:
. If the de-registration process was not successful, you may need to reset the
system and try again. To reset: pick up any registered handset and press the
PHONE�
FLASH
button, then press the
OFF�
CLEAR
button and place the
handset back into the base. You may also reset by unplugging the power from
the telephone base and plug it back in.
. You cannot de-register the handset(s) if any phone connected to your phone
line is in use.
NOT REGISTERED