Installation and setup
Connect the base and install batteries as shown below. After installation, place the
handset in the base and allow the batteries to charge for 8 hours before use. You can
keep the batteries charged by returning the handset to the base after each use.
Press coin into slot on
base of handset to
release latch, then
remove battery cover.
Insert supplied
batteries.
Place handset in base to charge
for 8 hours before first use.
Rotate antenna to fully upright
position.
Insert top
tab first.
To replace battery cover
Press down to
click in place.
Caution:
Use only the supplied NiCd battery or
AT&T model 2AA NiMH replacement battery
(SKU 26820).
Do not use alkaline batteries.
Plug power cord
transformer into
electrical outlet.
Plug long tele-
phone line cord
into telephone jack.
Route cords through
slot in base.
E2520 QSG.qxd 07/19/2004 3:21 PM Page 2
