Adding and registering handsets
Before using a new CL80111 handset, you must register it with the
AT&T CL83101/CL83201/CL83301/CL83351/CL83401/CL83451
telephone system (purchased separately). The telephone system
can support up to 12 handsets.
The handsets provided with your telephone system are already
registered as
HANDSET 1
and so forth. Additional handsets
registered to the telephone system are assigned in sequential
order they are registered (up
to
HANDSET 12
).
You must register each handset separately. When first purchased,
all expansion handsets show
Put HS on BASE to register
.
Register a handset to your telephone base
1. Make sure the handset is out of the telephone base
or charger and shows
Put HS on BASE to register
before you begin registration.
2.
Put the handset you wish to register on the
telephone base cradle.
3. Both the handset and the telephone base show
Registering... Please wait
and the
IN USE
light
on the telephone base turns on. Then
HANDSET X Registered
appears on both
the handset and the telephone base screens
(
HANDSET
represents the handset name,
X
represents the handset number)
.
Both the
handset and the telephone base beep and the
IN USE
light turns off. The handset is now
registered with the telephone base.
If registration fails, the system will
automatically try to register again. If
registration fails after the third try,
Registration failed
appears on both
screens. Then the handset shows
Put HS on BASE to register
and the
telephone base returns to idle mode.
This may take up to five minutes to
occur. Please start again from Step 1 above.
NOTE:
You cannot register a handset if any other system handset is in use.
Registration and deregistration
8
Put HS on BASE
to register
Registering...
Please wait
HANDSET X
Registered
