LINE jack on the back of the base. Plug the round con-
nector on the power cord into the POWER jack on
the back of the base.
4
Reverse the bracket and re-install it.
•
Turn the wall mounting bracket so the ribbed tabs are
facing the front of the unit.
•
Snap the bracket into the guides to lock it in place.
5
Connect the other end of the telephone line cord to the wall
jack plug and plug the power cord into a standard electrical
outlet.
6
Mount the base on the wall plate.
Align the holes in the wall-mounting bracket with the hooks on
the wall plate, and slide the base down until it locks in place.
7
Follow Steps 4 to 9 in Table/Desk Installation.
Wall Installation —
Without Existing Wall Plate
1
Choose a spot near an electrical outlet and a telephone jack.
This phone requires a modular wall jack and a standard
electrical outlet (110V AC).
2
Remove the bracket (see Step 2 above) and use it to mark
the position of the two screws that you will use.
•
It’s best to mount the base on wall studs.
•
Hold the bracket up to the wall (with the thicker end facing the
floor), and mark the wall through the screw holes in the bracket.
•
Screw two one-inch screws into the spots you marked,
leaving 3/16” extending from the wall.
3
Follow the directions for wall mounting on Existing
Wall Plate.
Use either the long or short line cord, depending on how far
you are from the phone jack.
Belt Clip
If you wish, you can attach the belt clip to the cordless handset,
using the illustration below.
I N S T A L L A T I O N
Push in on tabs and
remove bracket
(Step 2)
Connect the telephone
line cord to the base
(Step 3)
Align the base with the
hooks or screws and slide
down into place
(Step 7)
Reverse the bracket
and re-install it
(Step 4)
With Existing Wall Plate
2
