If necessary, you can press 2 to replay the message after listening to it, then press 3 when you are sure you
are deleting the right message.
Deleting All Messages
If you do not want to save any of your messages, press and release 3 3 after you listen to all your message
and hear the two-beep signal. The system erases all messages and memos that are stored in memory.
Recording a Memo
After you listen to your messages, you can record a memo to yourself or other members of the household.
1.
Press and release *
2.
Begin speaking after the beep.
3.
Press and release # when you are finished.
This memo will be counted as a new message.
Changing Your Announcement
To change your announcement:
1.
Dial your telephone number.
2.
Wait for the system to answer, then use the buttons on the telephone to enter your Remote Access
code.
3.
After you hear the two beeps, press and release 4*.
The system will beep and begin to record.
4.
Speak into the telephone in a normal tone of voice.
5.
When you are finished press and release #.
The system beeps to end the recording. When you hear two beeps, the system is ready for another
command.
To listen to your new announcement, press and release 4 1 after the two beeps. The system plays the
recording to the end, or until you press #.
Turning Off the system
Use the following procedure to turn off the Automatic Answering Feature:
1.
Dial your telephone number.
2.
When the system answers, enter your Remote Access code during or after the announcement.
3.
Press and release 8 8 after the two-beep signal to turn off the answering system.
The system beeps twice to indicate that the Automatic Answering feature has been turned off. It will not
answer incoming calls until you turn it on again.
When Memory is Full
When the system’s memory is full (or when the system is turned off), it answers after 10 rings by beeping
twice. The system does not play the outgoing announcement because it cannot record a caller’s message.
