When the Tape is Full
When the recording side of the tape is completely full, the system beeps, the
MESSAGE light flashes rapidly, and the system turns itself off because it cannot
record a caller’s message. The system answers calls after 10 rings and beeps,
but does not play an outgoing announcement or record the caller’s message.
Saving Messages on One Side of Tape
1
Remove the microcassette, turn it over, and reinstall it.
2
Fast forward the tape to the end of the reel, then press and hold
f
for approximately two seconds. The tape will reset.
3
Record a new outgoing announcement.
NOTE:
This method works only if the current recording side of the tape is
not full. If the tape is full, follow the directions below to save messages.
Saving Messages When Tape is Full
1
Unplug the system from the electrical outlet.
2
Remove the microcassette, turn it over, and reinstall it.
3
Wait for approximately 30 seconds, then plug the power adapter into the
electrical outlet. The system rewinds the tape.
4
When the tape stops (after about one minute), record a new outgoing
announcement.
NOTE:
You can listen to messages saved on the tape using a microcassette
player (purchased separately).
Changing/Removing the Microcassette
1
Press and release
O
to turn the system off.
2
Hold the microcassette at the indentation on the
lower left of the compartment. Lift the tape up
and to the right.
3
Turn the cassette over, or install a new cassette.
4
Press and release
O
to turn the system on.
5
After the tape resets, record a new announcement.
O P E R A T I O N
7
