Atak XD6220, Руководство по установке

Страница: 5 / 8

Fig. 2a
2-1/2” (65mm)
Fig. 2b
Fig. 2c
16"/
406.
4mm
1
1. Use a pencil, awl, or a nail to mark the location of the wall stud centers (Fig 2a) after locating the
stud with an electronic stud locator. The distance between marks should not be less than 16 inches
(Studs must not be less than 16 inches (40.6cm.)
2. Place the Wall Plate flat against the wall with the center of the Wall Plate in the desired location,
aligning the holes in the Wall Plate with the studs (Fig 2b). use the Wall Plate as a template to mark
the locatioin of the two mounting holes on the wall. Make sure that the mounting holes are level and
are parallel.
3. Use 7/32” (5.5mm) drill bit to pre-drill holes at least 2.5” inches (65mm) deep at the marked
locations.
4. Use a wrench, the two Lag Bolts (4) and M8 Washers (6) to attach the Wall Plate to the wall.
Do not use wall anchors in wood stud walls.
5. Use the magnet level placed on the front of the Wall Plate to level the mount, repositioning as
necessary, then firmly tighten the bolts. Do not overtighten.
7/32” (5.5mm)
4
4
6
6