Atag WS90211MX, Инструкция по эксплуатации

Страница: 97 / 112

Reposition the grease filter
The filter should be placed with the locking mechanism on the front. Open the filter access latch.
The notches at the front of the filter will then slot in. Hold the access latch in this position when placing
the filters.
1. Slot the notches at the back of the filter in the specially designed
opening of the cooker hood.
2. Tilt the filter upwards.
3. Release the filter access hatch. The notches at the back of the filter
will extend outwards and slot into the specially designed openings
of the cooker hood.
The filter is now in position again.
NOTE!
Replace the grease filters in their original assembled position. Positioning the grease filters
correctly ensures the most efficient extraction.
Replacing the odour/particulate matters (PM2.5) filter
The odour/particulate matters (PM2.5) filter must be replaced annually (or when indicated by the
odour/fine particle filter cleaning indicator).
The filter indicator will flash after 360 operating hours.
1. Remove the screw at the front securing the filter holder by turning it anti-clockwise.
2. Remove the filter holder with the filter out of the hood.
3. Remove the old filter and dispose of it with your residual waste.
4. Replace the new filter in the holder. Note: The arrow on the side indicates the airflow direction.
5. Replace the filter holder by first inserting the back into the notches.
6. Re-tighten the filter holder.
7. Reset the memory by long touching the – (minus) key until the filter indicator goes off.
13
Maintenance