Action
Possible causes
Problem
Press and hold the main power switch
until the display lights up.
You have forgotten to turn on the main
power switch.
The dishwasher does not start.
Check.
The door is not properly closed.
Check.
A fuse/circuit breaker has been tripped.
Check.
The plug is not plugged into the wall
socket.
Check.
The water tap is turned off.
Check.
Overflow/leaks.
Turn off the water tap. Pull out the plug
and call the service division.
A whirring sound (the drainage pump)
is heard from the dishwasher and does
not stop when the main power switch is
turned off.
Press and hold Start/Stop for three
seconds if you want to cancel the
Delayed start option.
Check that the Delayed start option has
not been selected.
None, next time the programme is run
the corrected time will be displayed.
The programme is taking longer than
estimated.
1 minute appears in the display.
Loosen the drainage hose where it con-
nects to the sink unit's water trap. Check
that no debris has fastened. Is the cone-
shaped part of the pipe cut to an inner
diameter of at least 14 mm?
Blocked drainage hose.
Water remains in the dishwasher.
Check that the hose is free from kinks
and sharp bends.
Kink in drainage hose.
Clean the coarse and fine filters.
The filters are blocked.
Clean the drainage pump. See the sec-
tion Care and cleaning.
Debris in the drainage pump.
Clean with washing-up brush and low
foaming cleaner.
Dirt around the seals and in corners.
Bad odour in dishwasher.
Run a programme with a higher temper-
ature about once a month.
Low temperature programmes have
been selected for a prolonged period.
Activate the Long dry option.
Drying power too low.
The dishes are not dry enough.
Fully load the dishwasher.
The dishwasher is not fully loaded.
Top up with rinse add or increase the
rinse aid dosage. See the sections
Rinse aid and Settings.
Rinse aid needs topping up or dosage
is set too low.
Open the door a little once the pro-
gramme has finished.
32
Troubleshooting