Atag VA6611PT, Инструкция по использованию и уходу

Страница: 32 / 36

32
Installation
DRAINAGE
Connect
drain hose
The drain hose runs to an inlet plug on the ink
unit’s water trap.
Note:!
The hose must be fastened on a level with the
underside of the sink unit.
Cut the drain hose adapter to the appropriate
size for connection to the undersink drain or gar-
bage disposer. The overall length of the drain -
age hose must not exceed 4,5 m.
No part of the drainage hose may be more than
950 mm above the bottom of the dishwasher.
The hose must not be run directly to the floor
drain or similar.
The hose must always discharge at least 350
mm above the bottom of the dishwasher.
• The supplied cone-shaped connection pipe fits
a drainage connection with an internal diam-
eter of 13, 16, 18 and 22 mm.
• Use a hose clamp if connecting to a fixed drain
(sink).
The connector is ready to cut to the desired
drain connection size. Only a clamp is required.
WATER CONNECTION
Connect water supply hose
Connec Use the supplied O ring and tighten
the connection by hand plus a quarter turn
with a wrench. Open the shutoff valve and
let the pressure settle for a while. Check the
connections again to make sure they are not
leaking.
Only use the inlet hose supplied with the
machine. Do not reuse old or other loose inlet
hoses
• Connect to hot or cold water?
If you use oil or electricity to heat your
home:
Connect the dishwasher to the cold water
supply.
If, on the other hand, you use district heat-
ing, solar power or geothermal power:
Connect the dishwasher to the hot water
supply (max. 70°C).
• The inlet pipe has a connector with either a
3/4” internal thread.
ELECTRICAL CONNECTION
• 220-230VAC mains voltage, minimum 10A
Only use the inlet hose supplied with the ma -
chine. Do not reuse old or other loose inlet
hoses.
CABLE/HOSE LENGTHS
Drainage hose: 1930 mm
Supply hose: 1670 mm
Power cable: 1770 mm