Atag VA2113QT, Руководство по эксплуатации

Страница: 65 / 156

Action Type of fault on the display
Clear the drainage pump. See the chapter Care and cleaning. If
the problem persists, call the service department. Overfilling F10
See “Water remains in the dishwasher” in the table “Problem”
below. If the problem persists, call the service department. Water outlet fault F11
Check that the water tap is on. Check that the outer filter on the
inlet hose is not blocked. See Unblocking the inlet hose filter in
the chapter Care and cleaning. If the problem persists, call the
service department. Water inlet fault F12
Turn off the water tap and call the service department. Inlet valve leakage F40
Clean the coarse and fine filters. Check that the outer filter on the
inlet hose is not blocked. If the problem persists, call the service
department. Water level fault F52
Turn off the water tap and call the service department. Overfilling F54
Call the service department. Circulation fault F56
Press any button to clear the error message.
Action Possible causes Problem
Wait a moment then try again. You have pressed the buttons
too soon after opening the door. The buttons do not react when
pressed.
Clean with a dry or slightly damp
cloth. The buttons are dirty.
Open the door. The buttons only
react to use when the door is
open. The door is closed.
Check that the baskets are
correctly positioned horizontally. The baskets are not correctly
positioned. Cannot close door.
Check that the dishes are not
blocking the baskets from
sliding properly into place.
Check the door lock. If it does
not click into place and lock,
open the door. The door lock does not click into
place and lock.
Press and hold the button for the
Auto open option until the button
starts flashing. Wait until it stops
flashing (60 seconds). Close the
door. Check that the door lock
clicks into place and locks.
25
Troubleshooting