Rev: 02/15/004
Transmitter Position
2. Commissioning
The Digital Thermostat and Receiver are pre commissioned (paired) at the factory.
However, if the Receiver or Transmitter has been changed then full commissioning will be required as
follows:-
1. Press and hold the black button of the receiver until the
LED light has flashed twice. Release the button and the
LED light will remain illuminated.
2. Press and hold MODE-button and SET-button of the
transmitter at the same time for more than 3 seconds to
enter into the User menu. Then press the OK-button until
RF Comm is displayed.
Remove wall
mounting rear panel
from Transmitter
Secure rear panel
to wall.
Note:
There
must be a top
clearance of at least
80 mm to allow the
front cover to be
raised upwards
Re-assemble
Transmitter to rear
panel
Slide the front cover
up, open the battery
compartment and fit
the batteries.
Ensure the batteries
(2 x 1.5V L26/AA)
are correctly fitted