Asymod BT-HPSA V2, Инструкция по эксплуатации

Страница: 13 / 16

- 13 -
Operation
Set Up the Audio Process Chain
Set up the audio process chain - whether computer based or rack gear. These
instructions are for a setup where a studio microphone and an audio process chain are
being used. Audio may be fed via the transceiver’s front panel microphone connector as
a last resort. For FM operation a hand microphone connected to the transceiver’s front
panel microphone connector must be used.
Set Up the Transceiver

Connect power to the transceiver.

Turn on the Asymod HPSA V2. Switch the Mains switch on the rear panel to the
ON position and turn the POWER switch on the front panel to the ON position.

Set mode to AM, the AM indicator should come on solid. Turn the TALKBACK off
and tune to the desired frequency.

Connect the dummy speaker 1/8” TS connector to the EXTERNAL SPEAKER jack.

Set the volume to 12 o’clock.

Connect the RF output of the radio to a good quality RF PEP power meter.

Connect the output of the RF PEP power meter to the RF input of an RF sampler.

Connect the output of the RF sampler to a well-tuned antenna or a 50Ω dummy
load.

Connect the SAMPLED output of the RF sampler to the input of a 30 MHz +
Oscilloscope (optional).