ASUSTOR 80-AS1104T00-MA-0, Быстрое руководство по установке

Страница: 13 / 26

13
Connecting and Powering on the NAS
1. Connect the NAS to its power supply.
2. Connect the NAS to your router, switch or hub using an Ethernet cable.
3. Press and hold down the power button located on the back of the device for 1 – 2 seconds until the yellow power LED
indicator is lit. This indicates that the NAS is now powered on. While the NAS is being powered on, the yellow system
status LED indicator will flash and the yellow network LED indicator will be lit as well.
4. The NAS is ready for operation once the yellow system status LED indicator has stopped flashing and remains steadily
lit. At this time, you should also hear a ‘beep’ from the system buzzer. Hardware installation is now complete. Please
move on to the software installation guide to configure your system settings.
Note: If the device has been subjected to strong shaking or shock, it is recommended that you remove the cover to
ensure that the hard disks are properly installed and that the screws are properly fastened.
AS1102T AS1104T