Asus T3-M2NC51PV - T Series - 0 MB RAM, Руководство пользователя

Страница: 36 / 88

2-20 Chapter 2: Basic installation
8. Connect the 4-pin power plug(s) to the power connector of the
optical drive(s).
9A. Connect the 4-pin power plug to the power connector of the IDE hard
disk drive, or the Serial ATA hard disk drive with a 4-pin power plug.
- or -
9B. For Serial ATA hard disk drive without a 4-pin power plug, connect
the 15-pin SATA power adapter plug to the power connector at the
back of the drive, then connect the other end (4-pin male) to a 4-pin
(female) power plug from the power supply unit.
Setting the switch to 115 V in a 230 V environment will seriously
damage the system!
See the Appendix for the power supply specifications.
The PSU has a 115 V/230 V voltage selector
switch located beside the power connector.
Use this switch to select the appropriate
system input voltage according to the voltage
supply in your area.
NOTE. The voltage selector is set to
230 V by default.
If the voltage supply in your area is 100-127
V, set the switch to 115 V. If the voltage
supply in your area is 200-240 V, set the
switch to 230 V.
REAR S
P
K
LINE
IN
FR
ONT
MIC IN
SIDE S
P
K
C T
R
B
ASS
eSA
T
A
Voltage selector