ASUS SpaceLink WL-100 WLAN PC Card
63
Chapter 4 - Troubleshooting
Chapter 4
4. Troubleshooting
The below troubleshooting guides provide answers to some of the more
common problems, which you may encounter while installing or using
ASUS SpaceLink PC Card products. If you encounter difficulties that are
not mentioned in this section, please contact ASUS Wireless LAN Techni-
cal Support.
Verify if the PC Card is installed correctly.
When the ASUS SpaceLink PC Card setup task is complete, you can verify
if the driver has been setup properly. Right click My Computer, select
Properties, and click the Device Manager tab. Then double-click the Net-
work adapters icon; you should see “ASUS SpaceLink WL-100 WLAN
PC Card” with an icon of expansion card. There should not be a “!” or “?”
(problem) or “x” (disabled) symbol over this icon.
There is a yellow exclamation mark or a yellow question mark
in Device Manager in front of my ASUS SpaceLink PC Card.
To resolve the problem, you should update/reinstall the ASUS SpaceLink
PC Card driver. In “Device Manager”, right click ASUS SpaceLink WL-
100 WLAN PC Card, select Properties, and select Driver tab. Click on
Update Driver button, then follow the “Update Device Driver Wizard” to
complete the driver installation.
In addition, you may be able to resolve this issue by reinstalling the driver.
Choose ASUS SpaceLink WL-100 WLAN PC Card, click Remove but-
ton in “Device Manager”, and then run the Add New Hardware Wizard
from the Control Panel.
Cannot connect to any Access Points
Follow the procedure below to configure your ASUS SpaceLink PC Card.
a. Verify that the “Network Type” is in “Infrastructure” mode.
b. Verify that the “SSID” of your ASUS SpaceLink PC Card is set to “any”
or set to the same “SSID” of an Access Point.
c. Verify that the “Encryption” type is the same as that of an Access Point.
If you enabled “WEP” encryption, you must also set the same WEP
Keys on both sides.
