Asus Q670EI-IM-A, Руководство пользователя, Страница: 20 / 59

Q670EI-IM-A
2-12
5. Chassis intrusion header (4-1 pin CHASSIS)
This header is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
By default, the pin labeled “Chassis Signal” and “Ground” are shorted with
jumper caps. Remove the jumper caps only when you intend to use the
chassis intrusion detection feature.
Q670EI-IM-A
PIN 1
+5VSB_MB
Chassis Signal
GND
CHASSIS
Connector type
HEADER 4p, K2, 2.54mm pitch
6. LVDS/EDP Panel Enable Signal Selection header (BKLTEN_SEL)
Pins
1-2 (Default) High Active
2-3 Low Active
1 2 2 3
High Active
(Default)
Low Active
BKLTEN_SEL
Q670EI-IM-A
Connector type HEADER 1x3p, 2.54mm pitch, S/T