
ASUS K8V-VM Motherboard
1-21
Single device
Cable-Select or Master
-
Black
Two devices
Cable-Select
Master
Black
Slave
Gray
Master
Master
Slave
Slave
2. IDE connectors (40-1 pin PRI_IDE, SEC_IDE)
The onboard IDE connectors are for Ultra DMA 133/100/66 signal cables.
There are three connectors on each Ultra DMA 133/100/66 signal cable:
blue, black, and gray. Connect the blue connector to the motherboard’s IDE
connector, then select one of the following modes to configure your device(s).
• Pin 20 on the IDE connector is removed to match the covered hole on the
Ultra DMA cable connector. This prevents incorrect insertion when you
connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.
If any device jumper is set as “Cable-Select,” make sure all other device
jumpers have the same setting.
K8V-VM IDE Connector
PRI_ID
E
SEC_ID
E
r
R
K8
V-
VM
Black or gray
Drive jumper
Mode
Cable
setting
of devices
connector
Содержание K8V-VM Ultra
Страница 1: ...Motherboard K8V VM User Guide ...
Страница 10: ... ...
Страница 72: ...2 36 Chapter 2 BIOS Information ...