20
Installation Quick Start Guide
RAID Software Suite Installation
— One blank high density floppy diskette† may be required to create the installation
diskette
•
SCO UnixWare* 7.1.1† OS software
† Not supplied
2.7.2
OS Installation Procedures
Note:
When installing UnixWare, create only one RAID device (host drive) on which the
operating system is to be installed.
1. Create and configure one RAID device from the BIOS of IIR Storage Console
(accessed by pressing <Ctrl>+<g>).
2. Insert UnixWare 7.1.1 installation diskette 1 of 2 which was included with your OS
user’s manual. Installation begins.
During the installation UnixWare prompts you to insert a Host Bus Adapter (HBA)
diskette. Insert the RAID Software Suite Driver Installation diskette. If you do not
have the diskette for the operating system that you are installing, then create it before
continuing. See
for instructions to create this disk.
3. During the installation of UnixWare, you will be prompted to install the Network
Information Services (NIS) package. By default the installation will configure your
system as an NIS client. See your system administrator for configuration of the NIS
services.
Note:
Installation of this service may take an extended period of time.
If you do not plan on using the NIS or there is not an NIS server present on your
network that you are installing this system onto, defer installation of NIS at this time
by pressing <F8> at the NIS configuration screen.
After completing the OS installation, proceed to
to complete the RAID
Software Suite installation.
2.8
RAID Software Suite Installation
2.8.1
Microsoft Windows 2000 and NT 4.0
1. Log into Windows using a user account with administrative rights.
2. Insert the RAID Software Suite CD-ROM in the CD-ROM drive. When the Intel
Integrated RAID splash screen (see
) appears, click on the link Install, to
launch the Setup program.
