Asus EBS-I10, Руководство пользователя

Страница: 31 / 59

EBS-I10 31
Bits per second
Allows you to select serial port transmission speed. The speed must
be matched on the other side. Long or noisy lines may require
lower speeds. Configuration options: [9600] [19200] [38400] [57600]
[115200]
Data Bits
Configuration options: [7] [8]
Parity
A parity bit can be sent with the data bits to detect some transmission
errors. Configuration options: [None] [Even] [Odd] [Mark] [Space]
[None] Disables parity check.
[Even] Parity bit is 0 if the num of 1’s in the data bits is even.
[Odd] Parity bit is 0 if the num of 1’s in the data bits is odd.
[Mark] Parity bit is always 1.
[Space] Parity bit is always 0.
NOTE:
Mark and Space Parity do not allow for error detection.
Stop Bits
Stop bits indicate the end of a serial data packet. The standard setting
is 1 stop bit. Communication with slow devices may require more
than 1 stop bit. Configuration options: [1] [2]
Flow Control
Flow control can prevent data loss from buffer overflow. When
sending data, if the receiving buffers are full, a “stop” signal can be
sent to stop the data flow. Once the buffers are empty, a “start” signal
can be sent to re-start the flow. Hardware flow control uses two wires
to send start/stop signals. Configuration options: [None] [Hardware
RTS/CTS]
VT-UTF8 Combo Key Support
Allows you to enable or disable VT-UTF8 Combination Key Support for
ANSI/VT100 terminals. Configuration options: [Disabled] [Enabled]