Programming LCD remote
T
O ENTER PROGRAMMING MODE
Press and hold the
button until one long beep is heard. Programming mode to customize the
remote’s response is now entered.
NOTE: If no buttons are pressed within 5-seconds,
programming mode will exit with 2-beeps.
B
EEPS
/V
IBRATION
O
N
/O
FF
Press
to select beeps/vibration On/Off. Beeps alone, or vibration alone, or beeps and
vibration, or no beeps or vibration can be selected. Refer to the table below for these settings.
Beep/Vibrate settings
Programming response
Icon display*
Beeps only (default)
1-beep
Siren icon On
Vibrate only
1-vibrate
Vibrate icon On
Beep & Vibrate
1-beep and 1-vibrate
Vibrate and siren icon On
No Beep and No Vibrate
1 long beep
Vibrate and siren icons Off
*
NOTE
: This is icon display during programming..
I
LLUMINATION
O
N
/O
FF
Press
to select LCD backlight illumination On/Off.
The LCD backlight will illuminate when a remote
button is pressed, or a alarm status page is received.
LCD Backlight settings
Programming response
ON
1-beep, backlight ON
OFF
2-beeps, backlight OFF
6
© 2006 Astroflex Electronics - All rights reserved
