Astroflame FingerKeeper, Инструкция по установке

Страница: 2 / 4

€
1.
With the door in the closed
position , place the wooden marker
block (supplied) vertically against
the frame.
With a pencil held at the side of the
block on the frame side,slide the
block from the top of the door to
the bottom,ensuring that the pencil
moves in conjunction with the block
leaving a pencil mark guideline
down the frame.
2.
With the door still in the closed
position, place the wooden marker block
vertically against the door and repeat the
same process of step 1, thereby leaving a
pencil guideline on both the door and the
frame.
3.
Now wedge the door in the fully
open€ position. (For metal doors and
kick-plates pre-drill with 2.5mm drill
bit.)
4.
Remove one layer only of the double
sided tape from each side of the
Fingerkeeper
device.
6.
Repeat this procedure to attach the
Fingerkeeper device to the door itself.
5.
Line up the edge of the Fingerkeeper
parallel to the guideline/pencil line on the
frame. Press€ firmly to hold in position
before finally securing with the screws
(provided) ensuring that there is a screw in
every hole of the device.
€
Please ensure you use the screws provided or an exact size and type of screw (3/8"no 4 size
flange-head self tapping screws type C)
Once fitted the device should be in position as shown in the animation below.