ASTRO U 960, Руководство по эксплуатации

Страница: 7 / 12

page 7
Important safety information
Operating Manual U 960 - Version 02-2022A

The device does not feature protection against water and may therefore only be operated and
connected in dry rooms. It must not be exposed to splash water or drip water, condensation or
similar effects of water, as this may impair the isolation from the mains voltage.

The electrical system supplying current to the device, e.g. a house installation, must incorporate
safety devices against excessive current, earth leakages and short-circuiting in accordance with
EN 62368-1.

All adhere to all applicable national safety regulations and standards.

Do not install the unit in locations with excessive dust formation, as this may impair the isolation
from the mains voltage.

Excess mechanical loads (e.g. falling, impacts, vibrations) may damage the insulation used to
provide protection from mains voltage.

High excess currents (lightning strike, surges in the power utility grid) may damage insulation used
to provide protection from mains voltage.

If there is no information about intended use (e.g. operating site, ambient conditions), or the opera-
ting manual does not include the corresponding information, then you must consult the manu-
facturer of this device to ensure that the device may be installed. If you do not receive any
information on this from the manufacturer, do not start operating the device.

Disconnect devices with damaged power cables from the mains power (unplug the power supply
plug).
Electromagnetic compatibility (EMC)
In order to avoid malfunctions from occurring when operating radio and telecommunications equipment,
as well as other operating units or broadcasting services, the following points must be observed:

Before installation, the device must be checked for mechanical damage. Damaged or bent covers
or housings may not be used.

During operation, the device must always be covered by the components provided for this
purpose. Operation with an opened cover is not permitted.
Maintenance

Read carefully: EN 60728-11 – Part 1, Safety requirements / No service tasks during electrical
storms!
Repair

Repairs may only be performed by the manufacturer. Improperly performed repairs may result in
considerable dangers for the user.

Do not start operating devices with a damaged power cable, and instead have them repaired by
the manufacturer.

If malfunctions occur, the device must be disconnected from the mains and authorised experts
must be consulted. The device may need to be sent to the manufacturer.