ASTRO CDM-700 Series, Руководство пользователя

Страница: 5 / 26

USER GUIDE
-2-
1. Turn Conveyor and Printer ON.
2. Feed stock through Printer and observe the way it is
received by the Conveyor.
3. Loosen Locking Knob [A] and adjust Stacker
Wheels so lead edge of media just touches Stacking
Rollers as it exits the Printer.
4. Adjust Speed Control to set the amount of overlap
between the pieces. (
For less overlap turn Speed
Control clockwise, for more overlap turn Speed
Control counterclockwise
.)
Reverse Operation
Conveyor is designed to run from right to left. It can also
operate from left to right. To switch operation direction,
first move Guide Roller Assembly and Stacking Tray to
opposite sides of the Conveyor. Then switch the
Reversing Switch (
located under Conveyor
) to the
reverse operating position.
Troubleshooting
If Conveyor fails to run, check for jammed
paper between Tapes and Roller. Also, check
Fuse and Motor Circuit Breaker and replace
or reset if necessary. Fuse Holders and Circuit
Breaker located on rear of Conveyor.
WARNING!
DISCONNECT POWER CORD WHEN CHECKING OR REPLACING FUSE!
ALWAYS REPLACE FUSE WITH THE SAME TYPE.
FAILURE TO DO SO MAY DAMAGE ELECTRONIC CIRCUIT BOARD.