ASTRO AstroJet 2000, Инструкция по установке, эксплуатации и ремонту

Страница: 10 / 62

6
Printhead Carriage
The AstroJet 2000 has five printheads. The heads are arranged in the following
configuration:
Head 1 is on a separate rail and can be positioned between the other two banks of heads.
Heads 2 and 3 are banked together as are heads 4 and 5. These heads share the same
rail assembly.
The AstroJet 2000 Layout software shows the position of the heads and how they are
banked together. For more information on this feature, please check Section 4
Operating
the AstroJet 2000 or the AstroJet 2000 software help program.
You can move the various printing banks from side to side to position the information
properly on the media with the following restrictions:
Head 1 prints a band 1/2” wide and may be positioned anywhere within a range of 9-3/8” on
the media. It can be positioned next to and stitched to Head 2 or Head 4 to form a printing
band 1-1/2” wide. It should not be positioned next to Head 3 or Head 5, as the exit rollers
will cause tracking on the printing from those respective heads.
Heads 2 and 3 and Heads 4 and 5 form a continuous printing bank of 1” each. The
maximum distance that these two banks can be placed apart is 9-3/8”. The minimum
distance they can be placed with respect to each other is 1-3/4”. When the banks are
placed that distance from each other Head 1 can be placed between them. It is
recommended that Head 1 be placed as close to Head 4 under these circumstances if a 1-
1/2” printing width is required.
A minimum of a 1/4” margin should be left at the top and bottom of the media to insure good
feeding and print quality. In addition a 1/4” margin should be left at the leading and trailing
edges of the media.