ll. SAFETY GUIDE:
lll. OPERATION GUIDE:
1.
For safety, read the USER’S MANUAL carefully before
use of the riveting adapter.
2. Wear
equate protective gear including ANSI
approved
goggles and
thick work gloves.
3.
Only use the riveting adapter with driving tool that
matches with requirements specified on
Product
Technical Data
.
4.
Switch off the driving tool before installing or
uninstalling
the riveting adapter.
5.
The objects to be riveted MUST BE SECURELY FIXED
BEFORE riveting in order to avoid possible injury.
Unsecured objects may rotate with the driving tool if not
secured.
6.
The driving tool MUST be stopped if user releases the
adapter’s body during riveting.
7.
During
Maintenance
and or when necessary, be careful
in the disassembly of inner plunger tube as there is a
pre-loaded spring inside.
WARNING:
The objects to be riveted MUST BE
SECURELY FIXED BEFORE riveting in order to avoid
possible injury. Unsecured objects may rotate with the
driving tool if not secured.
IMPORTANT:
Before using the rivet adapter on your
intended workpiece, use the adapter on a blind rivet
without a workpiece by just holding the tool in the air to
ensure your drill is powerful enough and on the correct
settings to pop a rivet.
• Note that riveting on a work piece will require at least 20
in/lbs more torque than this test.
CRITICAL:
Your rivet MUST NOT require more than the
maximum stroke limit of this tool which is 18 mm (0.7").
Ensure your drill is in "driver" mode and not drill mode.
I. Product Technical Data:
Dimensions:
Weight:
Hex Shank Size:
Riveting Capability:
Rivet Type:
Stroke Limit:
Working Torque:
Recommended RPM:
Requirements of Driving Tools:
ADR36
MODEL:
PRODUCT TYPE:
Page 2
8.5" x 5.5" x 2.4"
1.9 lbs
1/4"
Blind Rivet
Maximum 0.7 inch
Refer to section
III. Operation Guide
Low speed (<600 RPM)
Requirements of cordless driving tool:
• chuck capacity of at least hex 6.35 mm (1/4") shank
• min 12V and maximum torque > 190 in/lbs for aluminum and steel rivets
• min 14.4V and maximum torque > 250in/lbs for stainless steel rivets
Requirements of elctric or pneumatic driving tool:
• chuck capacity of at least hex 6.35 mm (1/4") shank
• with maximum torque > 190
in/lbs for aluminum and steel rivets
• with maximum torque > 250
in/lbs for stainless steel rivets
Rivet Size
Rivet
Material
3/32"
1/8
"
5/32
"
3/16"
Aluminum
Steel/Copper
Stainless Steel
BLIND RIVET DRILL ADAPTER KIT