ASTRO-MED Dash 16u, Быстрый старт

Страница: 9 / 13

II. Data Capture
DISCUSSION Set up one data capture for 7.28 seconds. The capture should be triggered when
the battery voltage is applied. The data capture should be a total of 7.28 seconds.
Of the total capture time, 0.728 seconds of the capture should show what the
signal looked like before the battery voltage was applied.
ACTION HOW TO
Enter data capture setup
[SYS] [SETUP DATA CAPTURE]
Format memory [ADVANCED] [FORMAT CAPTURE MEMORY] Use encoder wheel to
select 16 records x 256 Ks maximum. [BEGIN] [BEGIN] [EXIT] [EXIT]
Select capture of all channels
[SET CHANNELS TO STORE] [DEFAULT]
[EVENT CHANNELS] Toggle to SAVED to include event markers with the
capture. [EXIT]
Set sample rate to 1 kHz
[SET SAMPLE RATE] The number of samples per second. In general, select
at least ten times the frequency of your signal or the frequency of any changes in
signal. Turn encoder wheel until sample rate is 1 kHz.
Set record size to 64 Ks [SET RECORD SIZE] The Dash 16u will give you the amount of time that data
will be captured based on the record size and the sample rate. This is shown
under the duration field. Turn encoder wheel until record size is 64 Ks.
Set trigger window to 10% [SET TRIGGER WINDOW] Placing the trigger at any point other than the
start of the capture window will allow for pre-trigger data to be captured. Turn
encoder wheel until trigger window is 10%.
Set capture for one record [SET OPERATION] You can capture one record or re-arm for more captures.
Turn encoder wheel for single capture.
Be sure auto-triggering is OFF
[ADVANCED] [AUTO TRIGGER] If auto-triggering is ON, toggle to OFF.
Enter trigger setup
[SYS] [SETUP TRIGGER]
Enable waveform triggering
[WAVEFORM] Waveform should be toggled to ON position.
Set up the logic for triggering [TOGGLE LOGIC] Insure that OR logic is chosen.
Pick waveform(s) for triggering Turn encoder wheel so that only Channel #1 is selected.
Set up the level for triggering [SETUP WAVEFORM] [SET CHANNEL] Turn encoder wheel to select
Channel #1. [SET TYPE / CLASS] Use wheel to select level - above for type of
trigger. [<<FIELD>>] Turn encoder wheel to 80% (8.8 volts).
Run the chart [RUN / HALT]
Arm for capture
[ARM] This key is located near the encoder wheel. The Dash 16u is now
recording pre-trigger data, waiting for the trigger.