Astria.US.com
126727-01_D
36
GAS CONTROL MODULE SYSTEM
The module has 2 special features built into the system.
Continuous Pilot Feature
This allows the change from a spark to pilot system to a standing
pilot system.
1. There is a switch located on the right side of the module that
reads CONTINUOUS PILOT ON/OFF. This switch selects the
pilot's mode of operation (Figure 46).
2. When the continuous pilot switch is in the OFF position and the
appliance rocker switch is turned ON, the pilot will spark and
light. When the appliance rocker switch is turned OFF, the pilot
will shut OFF when the main burner shuts OFF.
3. When the continuous pilot switch is in the ON position and the
appliance rocker switch is turned ON, the pilot will spark and
light. When the appliance rocker switch is turned OFF, the pilot
will stay ON when the main burner shuts OFF.
Continuous Pilot
Off/On Switch
Remote/Off Switch
ADJ.
“S” Pilot Connection
“I” Pilot Connection
AF-4000 MOD Module Rt Side
Figure 49 - Gas Module Right Side
AF-4000 MOD Module Lt Side
AUX Connection
Learn Button
Figure 50 - Gas Module Left Side
Remote Control Feature
The module has a built in remote control receiver that allows the
user to program the remote transmitter at any time during or after
the installation of the burner.
1. There is a switch located on the right side of the module that
reads REMOTE/OFF (Figure 50).
2. When the remote/off switch is in the OFF position, the burner
will operate from the rocker switch or wall switch connected to
the two BROWN wires on the module.
3. When the remote/off is in the REMOTE position the burner will
operate from the Remote Control transmitter.
NOTE:
The module must be programmed to the Remote Control
transmitter.
•
To program the module (make sure the system has power),
locate the learn button on left side as shown in Figure 50. Press
and release the learn button. There will be a beep sound from
the module. Then press any button on the remote transmitter.
Once the module's internal receiver accepts the transmitter code,
there will be a series of confirming beeps.
•
The remote system is ready for use.
NOTE:
Make sure the valve module and light module are plugged into
the electric duct assembly.
BATTERY BACK-UP
This fireplace is equipped with a battery back-up. If the power was
to go out on the fireplace, the battery back-up allows the fireplace to
remain operational. Make sure to periodically check the condition of
the four AA batteries used for the battery back-up.
REMOTE CONTROL OPERATION
This remote control system was developed to provide a safe, reliable,
and user-friendly remote control system. The system can be operated
manually from the transmitter.
The transmitter operates with (4) AAA 1.5V batteries that are included.
Install the batteries supplied with the unit into the battery compart-
ment. It is recommended that ALKALINE batteries always be used for
this product.
Be sure the batteries are installed with the (+) and (-)
ends facing the correct direction.
When you start up the remote, if a low battery signal appears or if
the LCD screen does not illuminate when you touch it, check battery
position and if the batteries are fully charged.
Figure 51 - Remote Control Battery Compartment
BACK
Cont.
S M T W T F S
AM
PM
ROOM
SET
P1
A
B
P2
P2
AUX
P2
Pilot
:
OFF
ON
°
°
u
PROGRAM
USB
MODE/SET
BATTERY
COMPARTMENT
TOUCH SCREEN LCD AND BUTTON LAYOUT
Functional Description
Note:
All function adjustments will be automatically accepted 15 -
seconds after pressing a given touch zone or button. The user may
press the MODE/SET button to immediately accept the adjustment
manually.
