
Astria.US.com
126730-01C
24
OPERATION
Continued
CAUTION: Never touch the blower
wheel while in operation.
Note:
Blower assembly may have moved during
transit. Make sure blowers are properly mounted (see
Figures 36a and 36b for proper location).
1. Check to make sure that the power cord is com-
pletely clear of the blower wheel and that there
are no other foreign objects in blower wheel. Also
double check all wire leads and make sure wire
routing is not pinched or in a precarious position.
Correct accordingly.
2. Turn on power to duplex outlet if previously
turned off.
3. Plug in blower power cord to duplex outlet.
4. Turn blower on and check for operation. Turn
blower off by turning knob fully counterclock-
wise before continuing.
Figure 36 - Blower Assembly
Magnet
Exhaust Port
Ring Connector
Ring
Connector
Ring
Connector
Screw
Screw
Speed
Control
Ground Wires
Power Cord
Air Flow
Direction
Cork Gasket
Material
Cork Gasket
Material
Figure 36a - Blower Kit Location 36'' Models only
Figure 36b - Blower Kit Location 42" Models only
Note:
Refractory
Panels and Wires not
shown for clarity
Rear
firebox
Plenum
Location
Blower
Location
Left Side
Shown
Speed Control
BLOWER CONNECTION AND OPERATION
Note:
The blower assembly, is for application into direct-vent models listed on the front page of this manual only and is already factory installed.
When operating the blower, you must first check that all wiring connections are secure from the speed control to the blower (See Figure 36).