INNOVATIVE HEARTH PRODUCTS • CONTEMPORARY LINEAR VIEW DIRECT-VENT GAS FIREPLACE • REQUIRED AND OPTIONAL ACCESSORIES
2
Printed in U.S.A.
© 2015 INNOVATIVE HEARTH PRODUCTS, LLC
P/N 900079-08 Rev. NC 03/2015
P900079-08
NOTE: DIAGRAMS AND ILLUSTRATIONS ARE REPRESENTATIVE AND ARE NOT DRAWN TO SCALE.
1508 Elm Hill Pike, Suite 108
Nashville, TN 37210
IHP.us.com
Step 2.
Installing the gas shut-off valve;
a.
Pull gas flex line out from inside, beneath fireplace
floor.
b.
Place shut-off valve in valve bracket, threading flex
line through gap in back.
c.
Use coupler to attach additional flex line to shut-off
valve.
d.
Bend up tab on the side of valve bracket to hold
shut-off valve in place (Figure 3).
e.
Attach valve bracket to unit with two screws.
f.
Attach shut-off valve to incoming gas line with field-
supplied coupler.
Figure 3: Gas Shutoff Valve Bracket
Step 3.
Place unit in wall framing.
NOTE:
The provided non-combustible fiber board
may be faced with any NON-combustible finish
material appropriate for use (brick, tile, stone, high-
temperature paint, etc.). For painted wall finish, use
two (2) coats of quality primer and high-temperature
paint on provided fiber board.
Step 4.
Secure nailing flanges to wall framing.
Step 5.
Secure heat shield to top front of unit with two screws.
NOTE: Refer to the Instruction Manual (P/N
900079-02 for finishing details.
Step 6.
Place insulation flat across the top of the fireplace
lengthwise behind heat shield.
Step 7.
Cut noncombustible fireboard to size and install
flush with top of frame pieces.
Step 8.
Finish out wall with ½” finishing materials – paint
with high-temperature paint, etc.
Step 9.
Attach surround in frame using screws a minimum
of six at specified locations (Figure 2).
Step 10.
Install barrier mounting brackets on side of
surround.
Step 11.
If removed, reinstall door and secure with three
screws.
Step 12.
Install Gas Shutoff Valve Door (Figure 1).
Step 13.
Install barrier on barrier mounting brackets.
Figure 4: Attach the Surround to the Fireplace
Gap
(thread
flex
gas line
here)
Back Side
Tab (bend up
to hold valve)
f i r e - p a r t s . c o m