7
QG50 robotic cleaner
owner’s Manual
6
QG50 robotic cleaner
owner’s Manual
7.
Slide the control unit base / caddy handle attachment
down over the metal tubing until it snaps into place .
Figure 6.
Attach Caddy Handle
8.
Align cleaner hook pins with the top holes in the
handle tube and snap into place.
Figure 7.
Snap Cleaner Hook into Place
3.3
Attach the Control Unit to the Caddy
1.
Align the bottom of the control unit with the notch at
bottom of the control unit hook on the caddy .
Figure 8.
Align Control Unit with Caddy Hook
2.
Insert the metal handle frame tubing into the base
with notch end at the top, then rotate so the bends
are away from you.
3.
Push base down so the metal handle frame is seated in
the recess on the underside of the base.
Figure 3.
Connect Metal Frame to Base Unit
4.
Slide the handnut over the tube and twist to tighten
onto base unit.
Figure 4.
Twist Handnut to Secure Frame
5.
Snap two (2) support blocks into place.
6.
Slide axle and hubcap piece through center of wheel
and attach to base unit. Snap locking clip into place to
secure wheel. Repeat to attach both wheels.
Figure 5.
Snap in Support Blocks and Attach Wheels
