5
Fig. 3
Hardware Used
BB
AA
CC
CC
Bolt x
10
Washer x
10
Wood Dowel
Wood Dowel
x 4
x 4
E
F
CC
3. Locate LH end Panel (E) and RH end Panel (F),
insert one Wood Dowel (CC) into each of the
pre-drilled holes. Use Bolts (AA) and Washers (BB)
through the pre-drilled holes in the mounting blocks.
HAND TIGHTEN ONLY.
Fig. 4
Hardware Used
BB
AA
Bolt x
7
Washer x
7
G
CC
CC
AA
BB
4. Insert one Wood Dowel (CC) into each of the
pre-drilled holes on the top edges of the Assembly
from step 3. Then locate Mantel/Top (G) and lay
fi nished side up on top of completed assembly.
From the inside, attach Mantel/Top (G) using Bolts
(AA) and Washers (BB) through the pre-drilled holes
in the mounting blocks.
HAND
TIGHTEN
ONLY.
Using Phillips head screwdriver tighten all Bolts
alternating top and bottom, left and right.
Fig. 5
5. Attach the Metal Grate (H) to the completed Front
panel assembly from step 4. Insert one Screw (DD)
into each of the pre-drilled holes.
Make sure the screws are seated into the pre-drilled
holes in the Metal Grate (H). Tighten all Screws (DD).
DD
H
Hardware Used
DD
Screw
x 14
