ASSEMBLY INSTRUCTIONS
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
CAUTION:
Do not over tighten fasteners.
Figure 1
1. (SEE FIGURE 1)
Attach front wood slat (C)
with rounded edge facing out towards
the cast iron sides (B). Secure using two
round head screws (E), two washers (F),
and two nuts (G).
Repeat this step and attach rear slat (C).
Do not tighten at this time, leave
slats loose for adjustment later.
2. (SEE FIGURE 2)
After attaching front and
rear wood slats (C) to cast iron sides (B),
attach backrest (A) to cast iron sides (B),
using four round head screws (E),
four washers (F), and four nuts (G).
Do not tighten at this time, leave the slats
and backrest loose for adjustment later.
Do not install plastic nut covers (I) at this
time, they should be installed after all
hardware has been tighten securely.
3.
Attach the remaining four wood slats (C)
to cast iron sides (B) in the same method
as Step 1.
Do not tighten at this time, leave slats
loose for adjustment later.
4
.
Adjust the legs on the cast iron sides (B)
to a 90-degree angle and space out
wood slats (C) evenly.
Tighten all hardware securely.
5. (SEE FIGURE 3)
Attach middle support
bracket (D) to the bottom of the wood
slats (C) using six self-tapping wood
screws (H).
6. (SEE FIGURE 2)
Place the four plastic
nut covers (I) on the four nuts (G)
protruding from the back
of the backrest (A)
.
B
A
C
D
E
F
G
H
I
A
E
E
G H
G
H
C
E
B
F
G
Figure 3
D
C
H
Figure 2
C
PARTS & HARDWARE LIST
PART #
DESCRIPTION
QUANTITY
A
1
Arched Bench Back
B
5
Wood Seat Slats
C
2
Cast Iron Legs with Wood Armrest
D
1
Middle Support Bracket
6mm x 32mm Bolt
E
14
6mm Washer
F
14
6mm Nut
G
14
Phillips Wood Screw
H
Plastic Nut Cover
I
5
4
I
1
2
NOTE:
This product is intended for residential, non-commercial use.
